Preparing The Measurement - Sanitas SBC 53 Instructions For Use Manual

System requirements for the HealthCoach app
®
Bluetooth 4.0, iOS from Version 7.0, Android
Version 4.3 with Bluetooth
List of compatible devices:

4. Preparing the measurement

Inserting the batteries
• Remove the battery com-
partment lid on the rear of
the device.
• Insert 2x 1.5 V AAA (al-
kaline type LR03) batteries. Make sure that the batteries are
inserted the correct way round. Do not use rechargeable
batteries.
• Close the battery compartment lid again carefully.
All display elements are briefly displayed,
the display. Now set the date and time as described below.
If the battery replacement symbol
displayed, you can no longer perform any measurements
and must replace all batteries. Once the batteries have been
TM
devices from
®
Smart Ready
or
is permanently
removed from the device, the date and time must be set again.
Any saved measured values are retained.
The empty, completely discharged batteries must be disposed
of through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
The codes below are printed on batteries contain-
ing harmful substances: Pb = Battery contains
lead, Cd = Battery contains cadmium, Hg = Bat-
tery contains mercury.
Set the hour format, date, time and Bluetooth
settings
The following section describes the functions and settings
available on the blood pressure monitor.
Hour format
It is essential to set the correct date and time. Otherwise, you
will not be able to save your measured values correctly with a
date and time and access them again later.
flashes in
If you press and hold the M1 or M2 memory button, you
can set the values more quickly.
Press and hold the START/STOP button
All display elements are briefly displayed.
25
Date Time
➔ ➔
®
®
➔ Bluetooth
for 5 seconds.