Printing 4600N Information Pages; Resetting Usage Reports; Tcp/Ip Setup - NEC SuperScript 4600N User Manual

Printing 4600N Information Pages

You can print a number of different pages preformatted with
useful information about your printer. Follow these steps.
1. Press Online.
OFFLINE
2. Press Menu.
MENU - CONTROL
3. Press Next until
PRINT FORM
4. Press Select
.
5. Press Next until you see the page you want to print. Your
choices are,
DEMO PAGE, PS START PAGE, PS FONT PAGE,
and
MENU TREE PAGE,
6. Press Select.

Resetting Usage Reports

You should reset the Usage Status any time you replace the
Belt Cartridge, Fuser Cleaning Roller, or Fuser Unit. Follow
these steps. The example below shows how to reset the Usage
Report when you replace the Fuser Unit.
1. Press Online.
OFFLINE
2. Press Menu.
MENU - CONTROL
3. Press Next until
USAGE STATUS
4. Press Select.
5. Press Next until
REPLACE FUSER
6. Press Select, and when the panel displays
press Select again.
60 SuperScript 4600N — User's Guide
appears on the display.
appears on the display.
appears on the display.
SUPPLY ORDER.
appears on the display.
appears on the display.
appears on the display.
appears on the display.
CONFIRM

TCP/IP Setup

You can use the Operator Panel to enable and set up the
TCP/IP networking parameters for the printer. This is
particularly useful for setting the printer's IP address so you
can use it as the printer's URL in web-based printing. Follow
these steps.
1. Press the Online button of the Operator Panel.
appears on the display.
2. Press the Menu button to enter menu mode.
appears on the display.
3. Press the Next button until
on the display, and press the Select button.
4. Press the Next button until
display, and press the Select button.
5. Press the Next button until
and press the Select button.
6. Press the Next button until
display, and press the Select button.
7. Use the Operator Panel buttons to set values for each of
the 12 digits in this manner.
First press Next to set the curser to the first digit.
For the first digit, press Select to increment to the correct
value. Then press Next to move to the next digit and
,
press Select to increment to its correct value. Continue
until all twelve digits are set. When the final digit is set,
press Next to confirm the Net Address you set and then
press Select.
8. Press Menu to exit menu mode and press Online to
bring the printer online.
, and
SUBNET MASK
select , the TCP/IP protocol is enabled.
ENABLE
To validate any changes to network settings, you must turn
the printer off, and then on again.
For more information about networking the 4600N printer,
see the SuperScript Color Laser Network Guide.
COMMUNICATIONS
appears on the
NETWORK
appears on the display,
TCP/IP
appears on the
NET ADDRESS
are set in the same way. If you
GATEWAY
OFFLINE
CONTROL
appears