Cip Approval Mark; Health And Safety Of The User - Hilti DX 351 Original Operating Instructions

14. CIP approval mark

The following applies to C.I.P. member states outside
the EU and EFTA judicial area:
The Hilti DX 351 has been system and type tested. As a
result, the tool bears the square approval mark showing
approval number S 809. Hilti thus guarantees compli-
ance with the approved type.

15. Health and safety of the user

Noise information
The following table provides noise measurement information:
Powder-actuated tool
Type:
Model:
Caliber:
Power setting:
Application:
Declared measured values of noise characteristics according to 2006/42/EC Machinery Directive in
conjunction with E DIN EN 15895
Noise (power) level:
Emission noise-pressure level in the work station:
Peak sound pressure emission level:
Operation and set-up conditions:
Set-up and operation of the pin driver in accordance with E DIN EN 15895-1 in the semi-anechoic test room of
Mü l ler-BBM GmbH. The ambient conditions in the test room conform to DIN EN ISO 3745.
Testing procedure:
Enveloping surface method in anechoic room on reflective surface area in accordance with E DIN EN 15895, DIN
EN ISO 3745 and DIN EN ISO 11201.
NOTE: The noise emissions measured and the associated measurement uncertainty represent the upper limit for
the noise values to be expected during the measurements.
Variations in operating conditions may cause deviations from these emission values.
1 ± 2 dB (A)
2 ± 2 dB (A)
3 ± 2 dB (C)
Vibration
The declared total vibration value according to 2006/42/EC does not exceed 2.5 m/s
Further information regarding the health and safety of the user can be found at the Hilti web site: www.hilti.com/hse
Printed: 12.08.2013 | Doc-Nr: PUB / 5069821 / 000 / 02
Unacceptable defects or deficiencies, etc. determined
during use of the tool must be reported to the person
responsible at the approval authority (PTB, Braun-
schweig)) and to the Office of the Permanent Interna-
tional Commission (C.I.P.) (Permanent Internationial
Commission, Avenue de la Renaissance 30, B-1000
Brussels, Belgium).
DX 351
Serial production
6.8/11 red
max
Fastening 2 mm sheet steel to concrete (C40)
using X-U 27/32P8 nail
L 1 107 dB(A)
WA, 1s
L 2 101 dB(A)
pA, 1s
L 3 135 dB(C)
pC, peak
2 .
en
31