Checking The Communication State - NEC NEAX IPS NWA-008869-001 Installation Manual

Checking the routing table
Use the show ip route command to check the information stored in the routing table.
Router (config) # show ip route
IP Routing Table − 3 entry
Code : C − Connected, S − Static, R − RIP, O − OSPF, IA − OSPF inter area
E1 − OSPF external type 1, E2 − OSPF external type 2,
* − Candidate default
Timers : Age
R 192.168.1.0/24 [120/2] via 192.168.3.1, Ethernet0.0, 0 : 00 : 10
C 192.168.2.0/24 [0/1] is directly connected, FastEthernet0.0, 0 : 14 : 57
C 192.168.3.0/24 [0/1] is directly connected, Ethernet0.0, 0 : 14 : 44
Router (config) #

Checking the communication state

Checking
Use the ping command to send a packet from terminal A to terminal B to check that communication can
be performed normally.
CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
Enter
– 119 –
ROUTING SETUP EXAMPLES (IPv4)
NWA-008869-001 Rev.1.0
atch5001.fm