NEC VisuaLink 128/384 User Manual page 49

VisuaLink 128/384 User Guide
STEP
23. Locate the network cable (RJ45-RJ45) and
connect one end to the S/T LINE port of the
VisuaLink 128 or VisuaLink 384. Connect the
other end of the network cable into the network
interface provided in the room wall.
Note 1: If the NT1 or network switch resides 300
feet (91 meters) or more away from the
VisuaLink 128 or VisuaLink 384, it is
recommended that the TERM switch is
set to ON on the VL128.
Note 2: In the case a VL384 is being installed, the
network interface card must be taken out
of the system and the appropriate strap
must be set.
Note 3: If the VL 384 is being installed, Step 23
must be repeated three (3) times.
24. Locate the ON/OFF switch at the upper right
outside of the cabinet. Press the switch to the ON
position.
NDA-24230 Issue 2.0
ACTION DRAWING
RJ45 NT1 Cable
+
+
O
U
T
MIC1 MIC2
+ +
I
N
VIDEO2 VIDEO1 AUDIO
+
VisuaLink 128 Rear
RJ45 NT1 Cable
+
+
O
U
T
MIC1 MIC2 MIC3
+ +
I
N
VIDEO2 VIDEO1 AUDIO
+
VisuaLink 384 Rear
ON/OFF Switch
Chapter 4
+
MIC3
TEL S/T LINE
+
Serial1 Serial2/RMT DC IN 5V
-
+
+
TEL S/T LINE 1 S/T LINE 2 S/T LINE 3
+
Serial1 Serial2/RMT DC IN 5V
- +
Page 4-21