Table of Contents
Advertisement
VisuaLink 128/384 User Guide
STEP
17.
If an NT1 device has been purchased, locate the
device and unpack.
Note 1: If an NT1 was not purchased go to
23.
Note 2: Three NT1 are used for the VL384.
18.
Locate the dip switch on the rear of the NT1 and
set all to the ON position.
19.
Place the NT1 or the three NT1s on the second
shelf, to the right of the VisuaLink 128 or
VisuaLink 384.
20.
Locate the NT1 power cable. Plug cable into
power strip at bottom of cabinet and feed cable
through cable slot in rear of second shelf. Plug
second end of power cable into power input at rear
of the NT1.
NDA-24230 Issue 2.0
ACTION
Step
Foam Inserts
1 2 3 4 5
NT1
(one for 128)
(three for 384)
1 2 3 4 5
Chapter 4
DRAWING
Polyethylene
Bag
Packing Carton
POWER
U
NT1 REAR
1 2 3 4 5
VisuaLink 128/384
POWER
HEADSET
POWERLINE
B1
B2
POWER
U
Power Connection
Page 4-19
Advertisement
Table of Contents
