Table of Contents
Advertisement
Appendix D
Page D-2
2.
The network provider provisions the correct ISDN BRI and completes the
following list of questions.
ISDN BRI Service Specification needed:
As defined by Bellcore; the ISDN BRI simplified ordering code is EZ-ISDN1.
•
The ISDN BRI protocol National ISDN-1
•
The ISDN BRI service must be terrified and available from the customer's
local central office.
•
The D channel should not permit X.25 packet data
•
The ISDN BRI service must allow videoconferencing calls to be dialed on
either B channel or on both simultaneously
•
Both B channels must carry circuit-switched Videoconferencing data
•
The ISDN BRI Line requires one or two different SPID number.
•
The ISDN BRI service must be configured as a Terminal Type A
•
The ISDN BRI service must be automatic Terminal Endpoint Identifiers
(TEIs)
A.
User requires an (NT1) to use the ISDN BRI service ( ) Yes ( ) No
B.
If Yes, the ISDN BRI network provider can ( ) or cannot ( ) supply it.
C.
If the ISDN BRI network provider cannot supply the needed NT1, and then
who is recommended supply.
Name;
Company:
Phone #:
D.
Did the ISDN BRI service pass a loop qualification test at the user site listed
Yes ( )
Note: The ISDN BRI must pass a loop test at the user site before installation
begins.
E.
Check one of the following.
( )
The users ISDN BRI line doesn't require a Service Profile Identifier
(SPID) number for installation.
( )
The user's ISDN BRI line requires one SPID number and one director
number (also called) Sub-Address for installation
SPID #
( ) The user's ISDN BRI line requires two SPID number and two
directory numbers for installation
SPID 1 #
SPID 2 #
VisuaLink 128/384 User Guide
No ( )
Sub Address #
Sub Address 1 #
Sub Address 2#
NDA-24230 Issue 2.0
Advertisement
Table of Contents
