How To Sweep - Alto 3366XP Operator's Manual & Parts List

HOW TO SWEEP

P4134/0001
P4134
Do not turn the steering wheel sharply when the machine is in motion. The sweeper is very responsive to move-
Sweep in straight paths. Do not bump posts. Do not scrape the sides of the machine.
When the machine is in motion, do not push the directional / speed control pedal all the way forward. This is the
same as starting in "High" and will put a strain on the motor and drive system.
1. Pick up large debris before sweeping with machine. Flatten and remove bulky cartons from aisle before
sweeping large debris.
2. Use the machine to sweep debris from narrow aisles into main aisle. See Figure 17.
3. After the machine has made a sweeping run.
4. Push and hold the filter shaker control button for 20 to 30 seconds, the filter shakers will shake to unload
accumulated dust. The main broom and fan will turn off automatically. The filter shakers only work
when the hopper is in the sweep position.
5. Sweep debris from main aisle. See Figure 17.
6. Overlap of broom paths when sweeping. This will eliminate leaving dirty patches.
7. The machine will leave debris, while sweeping, when the hopper is full. Follow the hopper unloading cycle
outlined on page 18.
Replace main broom when bristles are reduced to 2-inch length. To order replacement brooms, see MAIN
BROOM. Replace side broom when bristles are reduced to 3-inch length.
1-28
SIDE AISLES
MAIN AISLE
SIDE AISLES
FIGURE 18
WARNING
ment of the steering wheel. Do not make sudden turns.
WARNING
WARNING
To order replacement brooms see SIDE BROOM.
NOTE
American-Lincoln
3366XP