GENERAL MACHINE MAINTENANCE
PARKING
BRAKE
BRAKE PEDAL
P4718
BRAKE ADJUSTMENT
1. Connect pull rod to brake lever then adjust to fit with brake pedal full up and the spring not attached.
2. Adjust tension knob on parking brake lever to hold machine on a 8 degree incline.
3. Attach the brake lever spring.
BRAKE DRUM ADJUSTMENT
1. Tighten the axle nut so that the wheel hub spins freely.
2. Set the brake adjusters so that brakes drag then back them off two (2) notches.PNEUMATIC WHEELS
PNEUMATIC WHEELS
The pneumatic wheels should be maintained at an inflation pressure of 100 PSI. Since the wheel rims are of a
split rim construction, the outer bolt circle maintains the wheel assembly in one piece when the wheels are
demounted from the machine.
1-36
TENSION KNOB
FIGURE 31
WARNING
Fully deflate tires before removing the rim bolts.
PULL ROD
BRAKE
ADJUSTER
BRAKE
LEVER
SPRING
AXLE NUT
American-Lincoln
3366XP