Security.code.and.password; Pin Code - AU Mirach IS11PT Basic Manual

Security Code and Password
You have to use each security code to operate the IS11PT.
You can use the security code and other passwords described below.
Take care not to forget your security code and passwords, because
they are required for performing various operations and using
subscription services.
● Security Code
① Using the Answering Service (Voice Mail) and Call Transfer
Usage
Example
remotely from a fixed-line phone
② Making inquiries, applications, and changes while using
Customer Service Center voice guidance, and au homepage
③ Configuring "Other settings" in E-mail settings
Initial The four-digit number you wrote on your subscription form
Setting
● Pattern/PIN/Password
Usage Setting/Canceling Screen
Example lock, Remote control
lock, etc.
Initial None
Setting
● PIN code
Usage Preventing unauthorized
Example use of the au IC-Card by
a third party
Initial 1234
Setting

PIN Code

If the PIN code is incorrectly entered three times consecutively, the
PIN code will be locked. Use the PUK code to unlock the PIN code.
■ PIN code
You can set the IS11PT to require PIN code entry every time the
power is turned on, to prevent unauthorized use of the au IC-Card by
a third party.
• At the time of purchase, the PIN code is not to be required to use
the phone. You can select "Lock UIM card" and set the PIN code to
be required. It is also required when setting "Lock UIM card".
• The initial setting of the PIN code is "1234". You can change the
PIN code to a four- to eight- digit number by selecting "Change UIM
PIN".
■ PUK code
Enter the PUK code when the PIN code is locked.
• PUK code is an eight-digit number given at the time of purchase,
and is printed on the back side of the plastic card where your au
IC-Card is attached.
• When you enter the PUK code, set a new PIN code by selecting
"Change UIM PIN".
• If the PUK code is incorrectly entered ten times consecutively,
contact an au shop, PiPit or the Customer Service Center.
◎ The PIN code is not initialized even after executing "Factory data reset".
3