Controls 7~9; Remote Controller - NEC NLT-20 Owner's Manual

Controls
All the functions can be controlled with the remote controller. Some functions can
also be adjusted with the buttons on the front panel of the set.

Remote controller

Before you use the remote controller, please install the batteries.
1. POWER
Turns the TV on from standby or off to standby mode.
2. MUTE
Turns the sound on and off.
3. NUMBER buttons
Select programme numbers.
4. PSM (Picture Status Memory)
Recalls your preferred picture setting
5. SSM (Sound Status Memory)
Recalls your preferred sound setting
6. I/II
Selects the language during dual language broadcast.
Selects the sound output.
7. MENU
Displays a main menu.
8. TV/AV
Selects TV, COMPONENT, VIDEO, S-VIDEO or PC mode.
Clears the menu from the screen.
9. SLEEP
Sets the sleep timer.
10. TV/PC
Selects TV or PC mode.
8
POWER
1 2
1 2 3
4 5 6
3
7 8 9
* 0 *
5
4 6
PSM SSM I/II
MENU TV/AV
7 8
PR
VOL VOL
OK
TV/PC
SLEEP
PR
9 10
TEXT/MIX Q.VIEW LIST
UPDATE TIME REVEAL HOLD
NS-201
Controls
11. PRxy (Programme Up/Down)
Selects next programme or a menu item.
12. VOLÏq (Volume Up/Down)
Adjusts the sound level.
Adjusts menu settings.
13. OK
Accepts your selection or displays the current mode.
14. Q.VIEW
Returns to the previously viewed programme.
Note : In Teletext mode, The Q.VIEW button is used.
15. TELETEXT buttons
These buttons are used for Teletext.
For further details, see the 'Teletext' section.
16. LIST
Displays the programme list menu.
Battery installation
uInserting batteries
1. Remove the battery cover by pulling it upward in the direction shown by the arrow.
2. Insert the batteries with correct polarity ( "+" to "+", and "-" to "-" ).
3. Replace the battery compartment cover.
* Install two high-quality 1.5V "AAA" alkaline batteries. Don't mix old batteries with
new batteries.
*Remove batteries when you won't use the remote controller for long time. Liquid
leakage from old batteries may cause operation failure.
uNotes for using remote controller
• Make sure there are no objects between the remote controller and its sensor.
• Don't place the remote control near a heater or in damp place. Strong impact to the
remote control may cause operation failure.
• Signal from the remote control may be disturbed by sun light or other bright light. In
this case, darken the room or move the TV.
POWER
1 2 3
4 5 6
7 8 9
* 0 *
PSM SSM I/II
MENU TV/AV
PR
12
VOL VOL
11
OK
13
SLEEP TV/PC
PR
TEXT/MIX Q.VIEW LIST
16
14
15
UPDATE TIME REVEAL HOLD
NS-201
9