Specifications; Operating Conditions; Install The Hardware - Axis Q6032 Installation Manual

AXIS Q60 Series

Specifications

Operating Conditions

The Axis product is intended for indoor use.
Product
AXIS Q6032
AXIS Q6034
AXIS Q6035
Power Consumption
NOTICE
NOTICE NOTICE
Use a limited power source (LPS) with either a rated output power limited to £100 W
or a rated output current limited to £5 A.
Product
AXIS Q6032
AXIS Q6034
AXIS Q6035

Install the Hardware

NOTICE NOTICE NOTICE
• (AXIS Q6034) Due to local regulations or the environmental and electrical conditions
in which the product is to be used, a shielded network cable (STP) may be appropriate
or required. Any network cables that are routed outdoors or in demanding electrical
environments shall be shielded (STP) and intended for their specific use. Make sure that
the midspan is properly grounded. For information about regulatory requirements, see
Regulatory Information, on page 2.
• (AXIS Q6032/Q6035) The product shall be connected using a shielded network cable (STP).
All cables connecting the product to the midspan shall be shielded (STP) and intended
for their specific use. Make sure that the midspan is properly grounded. For information
about regulatory requirements, see Regulatory Information, on page 2.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
Classification Temperature
IEC 60721-4-3 0 °C to 50 °C
Class 3K3, 3M3 (32 °F to 122 °F)
IEC 60529 IP52
PoE+ DC
21 W 24–34 V DC, max. 19.1 W
21 W
24–34 V DC, max. 19.2 W
23 W 24–34 V DC, max. 20 W
Humidity
10-85% RH (non-condensing)
15-85% RH (non-condensing)
20-85% RH (non-condensing)
AC
20–24 V AC, max. 26.5 VA
20–24 V AC, max. 26.7 VA
20–24 V AC, max. 30 VA
17