Conducting A Final Test - FujiFilm WP-FZX100 Owner's Manual

When closing the waterproof case, take care not to catch your fingers or
palm in the waterproof case.
To prevent water leaks
Any foreign particles attached to
the O-ring may cause a water leak.
Remove the foreign particles (see
p.21). If you cannot remove them,
replace the O-ring with a new one.

Conducting a final test

Carry out a final submersion test on the waterproof case after mounting the
digital camera. To check for water leaks, watch for any water leaking in while
immersing it in a water tank or a bathtub filled with water. Check it in a way
that lets you take it out of water immediately (to save the camera inside) if you
need to.
1
Immerse it in water for 30 seconds.
2
After slowly lifting the waterproof case out of water, closely check
for the following:
Water
droplets
Dip it slowly in
water.
Joint
Hair
• If you see a continuous flow of
air bubbles from the joint of the
waterproof case while in the water,
this indicates a leak.
• When all is well, operate the
buttons and take some test shots
while it is under water.
• Water droplets near the joint of the
waterproof case.
• Water pooled inside the waterproof
case.
EN-13
Lint Sand