Part Names And Functions; Front View / Rear View; Remote Control Unit - NEC MultiSync XP29, XM29 Plus User Manual

Part Names and Functions

Front View
9 8
Multisync
1 POWER .............................. Press to turn the main power on and off when
the AC power is supplied.
2 STANDBY/POWER ........ When this indicator is green, the monitor is
on; when the indicator is red, it is in standing
by.
3 Remote Sensor Window ... Receives infrared signal from the handheld
remote control.
4 RGB 2/+ .............................. Press to select an RGB video source that is
connected to the RGB 2 input terminals (BNC
type). When you are in the OSM mode, this
button works as the plus button.
5 RGB 1/- ............................... Press to select an RGB video source that is
connected to the RGB 1 input terminal (D-
SUB 15 pin type).
When you are in the OSM mode, this button
works as the minus button.
3 2 1
7 6 5 4
PROCEED VIDEO 1 VIDEO 2 RGB 1 RGB 2
EXIT ¥ ¥ | {
POWER
/STANDBY
Rear View
0
6 VIDEO 2/ .......................... Press to select an NTSC, PAL, SECAM or M-
NTSC compatible video source that is
connected to the VIDEO 2 input terminal (BNC
type or S-VIDEO 2 IN). When you are in the
OSM mode, this button works as the up button.
7 VIDEO 1/
......................... Press to select an NTSC, PAL, SECAM or M-
NTSC compatible video source that is
connected to the VIDEO 1 input terminal (BNC
type or S-VIDEO 1 IN). When you are in the
OSM mode, this button works as the down
button.
8 EXIT .................................... Press to exit the OSM mode. The OSM screen
disappears.
9 PROCEED .......................... Press to access OSM. The OSM screen is
displayed.
0 Remote Control Holder ..... Place remote control unit here when not in
use.
Terminal Board
NOTE: S-VIDEO IN terminals will take
preference over VIDEO IN terminals when
the video source is connected to each
terminal and VIDEO 1 or 2 selected.
3
4