Part Names And Functions; Front View / Rear View; Terminal Board - NEC R 37 Xtra User Manual

Part Names and Functions

Front View
PROCEED VIDEO 1
▼
EXIT
9 8 7
1 POWER ..................... Press to turn the main power on and off
when the AC power is supplied.
2 POWER/STANDBY .... When this indicator is green, the monitor is
on; when the indicator is red, it is in standby.
3 Remote Sensor Window ... Receives infrared signal from the handheld
remote control.
4 RGB 2/DTV/+ ............. Press to select an RGB video source that is
connected to the RGB 2 input terminals
(BNC type). When you are in the OSM
mode, this button works as the plus button.
5 RGB 1/- ...................... Press to select an RGB video source that is
connected to the RGB 1 input terminal (D-
SUB 15 pin type).
When you are in the OSM mode, this button
works as the minus button.
6 VIDEO 2/ ................. Press to select an NTSC, PAL, SECAM or
M-NTSC compatible video source that is
connected to the VIDEO 2 input terminal
(BNC type or S-VIDEO 2 IN). When you are
VIDEO 2 RGB 1 RGB 2/DTV
▼
− ＋
POWER
/STANDBY
3 2 1
6 5 4
PROCEED VIDEO 1 VIDEO 2 RGB 1 RGB 2
EXIT ▼ ▼ − ＋
POWER
/STANDBY
Rear View
POWER
DEGAUSS OFF ON
VIDEO 1 VIDEO 2 RGB 1 RGB 2
POSITION / CONTROL PROCEED
EXIT
SCAN
WIDTH HEIGHT SIDE PIN NORMAL
NORMAL
BRIGHT CONTRAST MUTE VOLUME
MULTIMEDIA MONITOR
RD-346E 79644641
VIDEO 1 VIDEO 2 RGB AUDIO RGB 1
IN
R L MONO ( )
BNC S BNC S
IN IN IN
THROUGH
OUT
THROUGH
THROUGH THROUGH OUT
OUT OUT HIGH 75
RGB 2
R/C /P G/Y/Y B/V /P H/CS
L ( MONO ) R R B B
HIGH 75 HIGH 75
IN
AUDIO AUDIO
R L MONO ( ) R L ( MONO )
IN IN
THROUGH
OUT
THROUGH THROUGH
OUT OUT HIGH 75 HIGH
0
in the OSM mode, this button works as the up
button.
NOTE: S-VIDEO IN terminals will take
preference over VIDEO IN terminals when
the video source is connected to each
terminal and VIDEO 1 or 2 selected.
7 VIDEO 1/ ................. Press to select an NTSC, PAL, SECAM or M-
NTSC compatible video source that is
connected to the VIDEO 1 input terminal
(BNC type or S-VIDEO 1 IN). When you are in
the OSM mode, this button works as the
down button.
8 EXIT ........................... Press to exit the OSM mode. The OSM
screen disappears.
9 PROCEED ................. Press to access OSM. The OSM screen is
displayed.
0 Remote Control Holder..... Place remote control unit here when not in
use.
3
SPEAKER SELECT REMOTE EXTERNAL CONTROL
INT EXT
EXT SPEAKER IN
RIGHT LEFT
SPEAKRES MUST
HAVE MORE THAN OUT
5WATT RATING
INPEDANCE 8 OHM
DIP SW
ON
V
1 2 3 4 5 6 7 8
AC IN
75

Terminal Board

4
7