Part Names And Functions; Front View / Rear View - NEC MultiSync XP29, XM29 Xtra User Manual

Part Names and Functions

Front View
PROCEED VIDEO 1
EXIT ▼
9 8 7
1 POWER .............................. Press to turn the main power on and off when
the AC power is supplied.
2 POWER/STANDBY
........ When this indicator is green, the monitor is
on; when the indicator is amber, it is in stand
by.
3 Remote Sensor Window ... Receives infrared signal from the handheld
remote control.
4 RGB 2/DTV/+ ...................... Press to select an RGB or component video
source that is connected to the RGB 2 input
terminals (BNC type). When you are in the
OSM mode, this button works as the plus
button.
5 RGB 1/- ............................... Press to select an RGB video source that is
connected to the RGB 1 input terminal (D-
SUB 15 pin type).
When you are in the OSM mode, this button
VIDEO 2 RGB 1 RGB 2/DTV
▼
− ＋
POWER
/STANDBY
3 2 1
6 5 4
PROCEED VIDEO 1 VIDEO 2 RGB 1 RGB 2/DTV
EXIT ▼ ▼ − ＋
POWER
/STANDBY
Rear View
SPEAKERS MUST HAVE
VIDEO 1 RGB1
MORE THAN 5WATT RATING
BNC S
IMPEDANCE 8 OHM AUDIO
EXT SPEAKERS 75 75
RIGHT LEFT IN R L(MONO)
IN
HIGH IN HIGH
THROUGH THROUGH THROUGH
OUT OUT OUT
VIDEO 2 RGB AUDIO
SPEAKER SELECT
BNC S R/C R /P R
INT EXT
75 AUDIO 75
AC IN R L(MONO) R L(MONO) IN
IN
HIGH IN IN HIGH
THROUGH THROUGH THROUGH THROUGH
OUT OUT OUT OUT
0
works as the minus button.
6 VIDEO 2/ .......................... Press to select an NTSC, PAL, SECAM or M-
NTSC compatible video source that is
connected to the VIDEO 2 input terminal (BNC
type or S-VIDEO 2 IN). When you are in the
OSM mode, this button works as the up button.
NOTE: S-VIDEO IN terminals will take
preference over VIDEO IN terminals when
the video source is connected to each
terminal and VIDEO 1 or 2 selected.
7 VIDEO 1/ ......................... Press to select an NTSC, PAL, SECAM or M-
NTSC compatible video source that is
connected to the VIDEO 1 input terminal (BNC
type or S-VIDEO 1 IN). When you are in the
OSM mode, this button works as the down
button.
8 EXIT .................................... Press to exit the OSM mode. The OSM screen
disappears.
9 PROCEED .......................... Press to access OSM. The OSM screen is
displayed.
0 Remote Control Holder ..... Place remote control unit here when not in
use.
3
PC / EXT CTL
DIP SW REMOTE
ON
IN
1 2 3 4 5 6 7 8
OUT
RGB 2
G/Y/Y B/C B B P H V
75
HIGH
Terminal Board
4
7