Removal Of Dvd Deck Parts - Akai CFTD2052 Service Manual

2. REMOVAL OF DVD DECK PARTS

2-1: LOADING MOTOR ASS'Y/START SW PCB ASS'Y/
END SW PCB ASS'Y (Refer to Fig. 2-1-A)
1. Remove the 3 screws (1).
2. Remove the Loading Motor Ass'y.
3. Remove the 2 screws (2).
4. Remove the Motor and Loading Worm.
5. Disconnect the following connector: (CP2).
6. Remove the screw (3).
7. Unlock the 2 supports (4) and remove the Start SW
PCB Ass'y.
8. Unlock the 2 supports (5) and remove the End SW
PCB Ass'y.
(1)
(1)
Motor
Loading Worm
(4)
(4)
• Screw Torque: 1 ± 0.2kgf•cm
NOTE
1. In case of the Loading Worm installation, check if the
value of the Fig. 2-1-B is correct.
When installing the wire, install it correctly as Fig. 2-1-B.
2.
Loading Worm
Motor
Safety surface for pressing
of the insert.
Start SW PCB Ass'y
DISASSEMBLY INSTRUCTIONS
(1)
Loading Motor Bracket
(2)
(2)
(3)
Start SW PCB Ass'y
End SW PCB Ass'y
(5) (5)
Fig. 2-1-A
29.7 ± 0.1mm
Fig. 2-1-B
End SW PCB Ass'y
Red
Black
Motor
Black
Red
Fig. 2-1-C
2-2: TRAVERSE UNIT ROD/TRAVERSE UNIT HOLDER/
CD DECK/INSULATOR (Refer to Fig. 2-2)
1. Remove the screw (1).
2. Remove the Traverse Unit Rod.
3. Remove the 2 screws (2).
4. Unlock the 2 supports (3) and remove the CD Deck
Block.
5. Remove the 2 screws (4).
6. Unlock the 2 supports (5) and remove the Traverse
Unit Holder.
7. Remove the 4 Insulators.
Traverse Unit Holder
Insulator
Traverse Unit Rod
• Screw Torque: 3 ± 0.5kgf•cm
2-3: MOUTH ASS'Y (Refer to Fig. 2-3)
1. Remove the 2 screws (1).
2. Remove the Mouth Ass'y.
(1)
• Screw Torque: 0.8 ± 0.2kgf•cm
B2-1
(2)
Insulator
(5)
(2)
(5)
(4)
CD Deck
Insulator
(4)
(1)
(3)
(3)
Mouth Ass'y
(1)
Insulator
Fig. 2-2
Fig. 2-3