Function Sleep; Function Chrono-Thermostat (Available Only Through The Remote Control); Automatic Switching On On1 - Centrometal CentroPelet ZS Instruction Manual

Function SLEEP

The mode SLEEP is another function developed to save
money. One hour after its activation, the system starts de-
creasing the set temperature automatically by 1°C.
Press the key SLEEP (1) on the remote control to activa-
te the function SLEEP. You will see the symbol
on the display of the remote control. Press the key SEND
(2) to transmit your selection to the stove.
The control panel on the stop of the stove will show the
new setting displaying the word "SLEEP" and the room
temperature and working power of the stove.
You can deactivate the function SLEEP whenever you want
just pressing the key SLEEP again and the key SEND to
confirm your selection.
Please note: if the stove is working in "Auto", it is
not possible to activate the function sleep.

Function chrono-thermostat (available only through the remote control)

With the function chrono-thermostat, you can schedule up to two automatic switching on and off of the stove per day. If you
want to repeat the switching on and off every day, then you need to use the function AUTO too (as explained in the paragraph
"Daily repeat AUTO").
WARNING: the time of the automatic switching on and off must be set when the remote control is Off!
WARNING: in the event of an even very short lack of current, you will miss the set time for the automatic switching on or off.
Once the power supply is back, please program the stove again using the remote control!
WARNING: the stove switching on at the scheduled time will keep the same temperature and power you set before you last
switched it off.
WARNING: please consider an interval of min. 20 minutes between the switching off and subsequent switching on of the stove.
In this way the unit will have time to arrange a complete cooling phase. In the event this minimal interval is not calculated, the
stove will not switch on as scheduled.
Program 1 (ON1 and OFF1)

Automatic switching on ON1

Please join the following procedure to set the time for
the automatic switching on according to the program 1:
Press the key ( 1). You will see the hours and minutes
and the symbol ON1 blinking on the remote control. Use the
keys (2) and
(intervals of 10 minutes). To scroll the time faster, keep the
keys (2) and (3) pressed.
Confirm your selection pressing the key
You will now read the set switching on time on the remote
control. Press SEND (4) to transmit your selection to the pcb
of the stove.
The LED chrono-thermostat will light up on the control board
indicating that the programming is on (5).
32
(3) to change the wished time
(1) once again.
2
1
AUTO
CANCEL
ON 1
2
3
4
1
AUTO
(5)
CANCEL
1
SET
2 3
6
4 5