Remove Monitor Stand For Mounting - NEC MultiSync LCD1530V User Manual

Tilt
Grasp both sides of the monitor screen
with your hands and adjust the tilt as
desired (Figure TS.1).
Remove Monitor Stand
for Mounting
To prepare the monitor
for alternate mounting
purposes:
1. Remove the connector
cover, hinge cover and
cable cover.
(Figure R.1)
2. Disconnect all cables.
3. Place monitor face
down on a non-
abrasive surface.
(Place the screen on a
32 mm platform so that
hole of stand match to
screw location) (Figure R.2).
4. Remove the 4 screws
connecting the monitor to the
stand and lift off the stand
assembly (Figure R.2) the
monitor is now ready for
mounting in an alternate
manner.
5. Connect the AC cord and
signal cable to the back of the
monitor.
6. Reverse this process to
reattach stand.
Figure TS.1
Figure R.1
32mm
Screws
English-9
Push
Push
Figure R.2