Philips HD9150 User Manual page 11

If the vinegar starts to boil over the edge of the base, unplug the appliance and reduce the
amount of vinegar.
6 When the appliance beeps, unplug the appliance and let the vinegar cool down completely.
Then empty the water tank.
7 Rinse the water tank with cold water several times.
Note: Repeat the procedure if there is still some scale in the water tank.
storage
1 Make sure all parts are clean and dry before you store the appliance (see chapter 'Cleaning
and maintenance').
2 To store the mains cord, wind it round the reel in the base (Fig. 22).
3 Place the drip tray on the base (Fig. 5).
4 Make sure the removable bottoms are in place in the steaming baskets.
5 Place the large steaming basket (3) on the drip tray. Place the medium steaming basket (2) in
the large steaming basket (3). Place the small steaming basket (1) in the medium steaming
basket (2) (Fig. 23).
6 Specific types only: Place the soup bowl in the small steaming basket.
7 Place the lid on the soup bowl (specific types only) or on the small steaming basket (Fig. 24).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at www.
philips.com/support or contact the Philips Consumer Care Centre in your country. You find its
phone number in the worldwide guarantee leaflet. If there is no Consumer Care Centre in your
country, go to your local Philips dealer.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 25).
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, visit www.philips.com/support for
a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem
The steamer does
not work.
Possible cause
The steamer is not plugged in. Put the plug in the wall socket.
There is no water in the
water tank.
You have not pressed the
start/stop button yet.
Solution
Fill the water tank.
Press the start/stop button
EnglisH
11