Fisher & Paykel OR90SDBGFX Installation Instructions And User Manual page 29

Before using your cooktop
Before using your new cooktop, please:
Read this user guide, taking special note of the 'Safety and warnings' section.
Turn the power to the cooker on at the wall.
Make sure all burner control dials are turned off.
Using the gas burners
Choose the control dial for the burner you want to use.
1
Semi-rapid and triple-ring burners: press the dial in gently and turn it anticlockwise to the
2
position. The ignitors on all the burners will spark.
Dual burner: press the dial in gently and turn it anticlockwise to the
inner and outer crowns) or press the dial it gently and turn it clockwise to the
ignite the inner crown only). The ignitors on all the burners will spark.
Hold in the dial for approximately 10 seconds after the burner has lit. Releasing the dial too soon
will extinguish the flame.
Adjust the flame anywhere between
3
adjust the flame between
Note: If the burner does not light within 15 seconds, turn the control dial off and wait at least
one minute before trying again.
To turn the burner off, turn the dial clockwise (semi-rapid and triple-ring burners or dual burner
4
when using both crowns) or anticlockwise (dual burner when using the inner crown only) to 0
(OFF) until you hear the safety click.
After use, always turn the dials to the 0 (OFF) position.
5
Flame failure safety feature
The flame failure probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner on flame failure models, hold down the dial for approximately 10
seconds after the burner has lit. Releasing the dial too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for
at least one minute (to allow the gas to disperse).
Using your gas cooktop
and or
or or and 0 (OFF).
position (to ignite the
and or and
27
position (to
positions. Do not