NEC UNIVERGE SV8100 Service Information Bulletin page 29

Building the configuration file:
•
Launch the IP phone manager software
Click on Terminal
Document No. SIB 244
NEC Australia Pty Ltd shall not be liable for any direct, indirect, consequential or incidental damages about the use of the information included in this document.
The information in this technical documentation is advisory in nature and is subject to change. NEC may make improvements and changes in the products
described in this documentation without notice. Contents of this document are subject to change without prior notice at the discretion of NEC Australia Pty Ltd.
This document has been prepared for use by employees and dealers of NEC Australia Pty Ltd and may not be reproduced without prior written approval of NEC
Australia Pty Ltd.
Once the software is launched click on
the "Auto Config" tab.
Page
The basic settings needed to get the
phone working out of the box are:
st
1 server address
st
1 server port
Assign the IP address programmed in
st
PRG 10‐12‐09 to 1 server address.
Assign port 5080 to first server port.
29 52
of
st
1 July 2008