Adjustment - Kenwood TK-5210 K Service Manual

TK-5210
Cotrols
Selector
Volume
Side 1 key
PTT switch
Side 2 key
Side 3 key
Panel Test Mode
For the K model (without LCD), perform "Test mode" using
the KPG-95D.
■ Test mode operation features
This transceiver has a test mode. To enter panel test
mode, press and hold the [Side3] and [PTT] keys while
turning the transceiver power on and then the [PTT] key
first. Test mode can be inhibited by programming. To exit
test mode, switch the power on again.
• When the panel test mode is activated, the channel se-
lected with the [Selector] knob and the last used signaling
number are displayed. When it is activated for the first
time, the signaling number is 1.
• If test signaling 20 (Tone Test Pattern) is selected, the re-
sult of Bit Error Rate (BER) calculation is shown on the
transceiver LCD. The BER value is also output from the
serial port.
• The APCO and analog modes are switched automatically
by selecting test signaling. When APCO mode is effec-
tive, "A" is displayed on the LCD.
40

ADJUSTMENT

Concentric Switch
A
Universal
connector
Lever switch
Orange key
(K2 and K3 models only)
• Key operation
Key Function
[Selector] Test frequency channel up/down Channel No.
[Concentric switch] Channel spacing switching
(Position "A":Wide,
Position "B":Narrow,
Position "C":APCO)
[Lever switch] RF output power switching
( :Low power,
_
[PTT] Transmit
[Side1] Squelch level change
(0t1t2t t9t0t1t2t
• • •
[Side1] Hold Squelch off
[Side2] MSK baud rate change
(1200bps/2400bps)
[Side2] Hold Compander on/off
[Side3] Shifts to the Panel tuning mode -
[Side3] Hold LCD all lights
[Orange] Beat shift on/off
[A] Unused
[B] Unused
[C] Test signaling down
[D] Test signaling up
[0] to [9] and Use as the DTMF keypad.
[#], [*] If a key is pressed during transmission,
the DTMF corresponding to the
key that was presses is sent.
• LED indicator
Red LED Lights during transmission. Blinks at the low
battery voltage warning.
Green LED Lights when there is carrier.
• LCD display in the panel test mode
W: Wide
N : Narrow
A : APCO
W
1 1
-
Channel No. Signaling No.
• Filter Mode
Display Condition
W WIDE (25kHz) Filter
N NARROW (12.5kHz) Filter Concentric switch "B"
A APCO (12.5kHz) Filter
Display
Wide :"W"
Narrow :"N"
APCO :"A"
Low power :"LO"
:High power) High power :"HI"
-
-
Squelch level 0:"SQ.LV0"
) Squelch level 1:"SQ.LV1"
• • •
Squelch level 9:"SQ.LV9"
2400bps: icon
appears
On: icon appears
LCD all point appears
On: icon appears
-
-
Signaling No.
Signaling No.
-
LO
1
SQ. LV
[ None ]
Key
Concentric switch "A"
Concentric switch "C"