Kenwood TK-5210 K Service Manual page 12

TK-5210
■ Installing a new LCD ASSY to the holder (K2
and K3 models only)
1. Remove the separation paper (brown) from the new sheet
1 2
, and attach the sheet to the surface of the holder
2. Remove the protection sheets attached to both sides of
the new LCD ASSY.
3. Remove the separation paper (white) from the sheet in
4
step 1 , then attach the LCD ASSY
4. Attach two pieces of double-sided adhesive tape
back of the holder and remove the separation paper.
5. Remove the protection sheet (transparent) attached to
one side of the new filter
sheet (yellow) from the other side
6. Attach the filter from step 5 to the back of the holder.
7. Attach the new cushion
the holder convex.
1
2
3
10
6
6
8
9
■ Preparation when Replacing the Cord ASSY
(X42-3270-10)
Cut the tip of the FPC on the side on which "TX-RX" is
stamped when replacing the cord ASSY.
Cord Assy(X42-3270-10)
TX-RX
CUT
12
DISASSEMBLY FOR REPAIR
5
to the sheet.
6
7 8
and remove the protection
9
.
0
so that it fits to the corner of
10
5
4
1
3
6
7
6
CONT
■ Procedures when Replacing the Top Panel
1. Insert the O-ring
top panel.
3
. 2. Apply grease to the base of the shaft of the lever knob
and install the lever knob so that it is in the " - " position
(circle painted in white) on the top panel
3. Pass the hardware fixture
it onto the top panel.
to the
4. Apply grease to between the two holes in the hardware
4
fixture .
5. Install the hardware fixture
hole on the left side of the hardware fixture
6. Fix the two hardware fixtures with the hexagon nut
7. Apply bond (Three Bond 1401C) to the tip of the lever
knob shaft and the surface of the hexagon nut
Inserted into the hole
on the left side of the
5
hardware fixture.
7
Apply bond (Three Bond 1401C)
to the tip of the lever knob shaft
and the surface of the hexagon
nut.
■ Volume Knob and Channel Knob Parts Replace-
ment
Since the volume knob consists of two components, a
1
knob and a spacer
parts at the same time.
Since the channel knob consists of three components, a
3
knob , a 16CH display seal
and reinstall these three parts at the same time.
Volume Knob
2
1
into the lever switch part of the new
3
.
4
through the shaft and install
5
so that it is inserted into the
3
2
1
4
5
6
Top panel
Apply grease to the
base of the shaft of
the lever knob.
Apply grease to between
the two holes in
the hardware fixture.
2
, replace and reinstall these two
4
and a spacer
Channel Knob
5
3
1
4
2
4
.
6
.
7
.
5
, replace