Back Housing - Motorola iDen i850 Field Service Manual
Digital multi-service, data-capable portable
Hide thumbs
Also See for iDen i850:
- User manual (185 pages) ,
- User manual (212 pages) ,
- Manual (171 pages)
Table of Contents
Advertisement
PREPARING FOR FIELD LEVEL TESTING: Back Housing
7.10
Back Housing
Required Tools: T-6 Torx bit, black stick.
Preparation: Remove battery cover, extend antenna. Open audio jack seal and accessory
7.10.1 Remove:
1. Remove four T-6 screws—one in the antenna tube channel (see Figure 7-4).
2. Gently squeeze the front housing at the number 7 and 9 keys to separate the housing clips (see
Figure 7-5). Once the housings are free, do not stress flex strip near PTT key. Remove audio
jack seal.
3. Wedge black stick under flex pad to unseat speaker/vibe/coin/PTT/SB 20-pin flex connector
(see Figure 7-6).
NOTE: Do not touch flex contacts with fingers or dirty tools. Do not bend or crease the flex strip.
7.10.2 Install:
1. Reattach flex connector carefully without contamination.
2. Bring housing halves together checking alignment of Flex, PTT/Volume Keypad, and Audio
Jack Seal. Press housing halves together at number 7 and 9 key locations to engage clips.
3. Torque screws to 1.8 in/lb (2.1 in/lb new).
7-8
connector seal.
Figure 7-4.
68P80400P94-O
Advertisement
Table of Contents
Troubleshooting
