Using The Optional Vibrate Function - Motorola iDen i850 Field Service Manual

DISPLAYS, MESSAGES, AND ALERTS: Using the Optional Vibrate Function
Table 3-4. Alert Tones (Continued)
Tone Low
Self-Test Fail Spkr
Speaker Volume Set Spkr
System Busy Ear
Talk Permit Ear
Talk Prohibit Ear
TOT Warning Ear
Valid Key Press Ear
Voice Mail Spkr
Received in Idle
Voice Mail Ear
Received in
Interconnect
3.5

Using the Optional Vibrate Function

The vibrate function (VibraCall) notifies the user of incoming phone or dispatch calls, DC/GC calls,
messages, notifications, and call alerts.
If the unit is set for Vibrate in any mode, it will vibrate for 1/2 sec during the power-up sequence.
To set unit to vibrate for all calls:
1. Using the keypad, press the Menu key .
2. Scroll to Ring Tones, then press the OK button.
3. Scroll to Vibrate All, then press the OK button.
4. Scroll up or down to set Vibrate All on or off.
5. After you select a Vibrate mode, the unit vibrates for 1/2 sec while exiting the menu.
The following table describes the cadence for each vibrator mode:
Table 3-5. Vibrator Settings
Mode
Vibrate All or Selectable Vibrate
Ring Tones
Off
3-6
High Freq Cadence
Spkr 900Hz 1x500ms on
Spkr 1000Hz Continuous
Spkr 480/ 4x(0.25s on+0.25s off) 480Hz; 4x
620Hz (0.25s on+ 0.25s off) 620Hz
Spkr 1800Hz 2x (24ms on+24ms off) + 48ms on
Spkr 900Hz Continuous
Spkr 900Hz 1x80ms on
Ear 1800Hz 1x80ms on
Spkr 2400/ 8x(64ms on 2400Hz + 64ms on
2743Hz 2743Hz) every 30 seconds
Ear 2400/ 8x(64ms on 2400Hz + 64ms on
2743Hz 2743Hz) every 30 seconds
Cadence
2x(500ms on, 500ms off) + 500ms on + 2.5 sec. off
Three Vibrate Only cadences, followed by an audible ring tone
until answered or party hangs up
Turns off the vibrator function
When Tone Occurs
Self test fails on power up
Volume changed on quiet
channel or in Programming
Menu
All channels are busy
PTT transmission accepted
PTT transmission not allowed
Transmission rights expiring
Valid key pressed or unit
powered up
Voice mail received while unit is
idle
Voice mail received while unit is
in interconnect mode
68P80400P94-O