To connect the unit to a PC using the iDEN RS-232(serial) or USB data cable (Figure
6-1):
1. Insert the 17-pin connector on the data cable to the 17-pin connector located at the base of the
unit.
2. Attach the other end of the data cable to the RS-232 port or USB port on the RSS computer
workstation that is used for testing purposes.
Refer to any relevant Radio Service Software Read-Me's or active iDEN Service Bulletins for more
information on setting up your test computer as an RSS workstation.
NOTE: For faster codeplug reading using an RS-232 connector, enable the QuickComm feature in
the RSS configuration setup.
68P80400P94-O
BASIC LEVEL TEST MODES AND PROCEDURES: Connecting the Unit to the RSS Workstation
Figure 6-1. Data Cable Programming Setup
6-9