Motorola iDen i850 Field Service Manual page 74

PREPARING FOR FIELD LEVEL TESTING: Flip Assembly
7.12.2 Install:
Required Tools: Black stick.
Preparation: Check that the Flip is in the open position.
1. Align flip assembly to front housing. Carefully guide the Flex connector through opening in
front housing. (see Figure 7-12.)
2. Slip the left knuckle side of the Flip Assembly into position. (see Figure 7-13.)
3. Insert black stick in cam mechanism side to press on hinge while inserting left knuckle into
position while aligning flip and housing. (see Figure 7-13.)
4. Continue to carefully push the Flip Assembly into position with the front housing.
5. Once set, check the hinge position by opening and closing the flip looking for binding or other
unusual action. Flip should open smoothly and close completely.
7-12
Figure 7-12.
Left Knuckle
Hinge/Cam
Figure 7-13.
68P80400P94-O