Shutting Down; Maintenance And Care - Kärcher SE 4001 Manual

Illustration
 Remove the spray hoses and mounting
clips from the suction hose and suction
pipes.
 Press the two locking noses on the
sides and pull the spray handle off the
handle.
Illustration
 Insert a filter bag.
 Select the desired accessories and at-
tach to the suction pipes or directly to
the handle.
 Switch on suction (position I).
Vacuuming hard surfaces
 Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Vacuuming carpeted floors
 Work without the hard surface insert.
Illustration
 Use the surrounding air separator to
adapt the suction force.
Note: Close the surrounding air separa-
tor again after use!
Wet vacuum cleaning
Caution
Do not use a filter bag!
Immediately switch the appliance off or pull
the power plug if foam forms or liquids es-
cape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
 Switch on suction (position I).
Illustration
 Open the surrounding air separator if
water is suctioned from a tank. Close it
again after use.
 Empty the full reservoir (refer to chapter
"Empty reservoir").
Downloaded From Vacuum-Manual.com Manuals

Shutting down

 Turn off the appliance.
 Empty the full reservoir (refer to chapter
"Empty reservoir").
 Rinse the reservoir thoroughly with
clear water.
 Remove the accessories from the appli-
ance after each use and disassemble
the hose, nozzle and extension pipes.
Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
 Flush the accessories separately under
running water and let air dry.
 Clean the foam filter under running wa-
ter; let it dry before reinserting it.
 Leave the appliance open to let it dry.
 Storing the appliance. Store the ac-
cessories on the appliance and store in
dry rooms.

Maintenance and Care

Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Cleaning the device
With an uneven spray jet.
Illustration
 Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
Clean the sieve in the fresh water
1 x year or as needed.
Illustration
 Turn the lock and loosen it. Take out
the sieve and rinse it with water.
– 10
EN
reservoir
17