Crutch Holder; Lap Belt - Quickie Helium Directions For Use Manual

Anti-Tip Tubes...
Active Anti Tip for Sport
To remove the active anti tip for sport, press the button of
the quick release pin and pull it out. Now pull out the tube
from the anti tip receiver, (4.31.2 - 4.31.3).
Fig. 4.31.2
Fig. 4.31.3

Crutch holder

Crutch Holder
This device permits crutches to be transported directly on
the wheelchair. It has a Velcro loop to fasten crutches or
other aids.
CAUTION!
Never try to use or even remove the crutches or other
aids while moving.
18

Lap belt

DANGER !
• Before using your wheelchair ensure the lap belt is
worn.
• The lap belt must be checked on a daily
• basis to ensure it is free from any obstruction or
adverse wear.
• Always make sure that the lap belt is correctly
secured and adjusted prior to use. If the strap is too
loose it could cause the user to slip down and risk
suffocation or cause serious injury.
The lap belt is fitted to the wheelchair as shown in the
illustrations. The seat belt comprises 2 halves. They are
fitted using the existing seat stay retaining bolt fitted
through the eyelet on the belt. The belt is routed under
the rear of the side panel. (Fig. 4.32)
Adjust the belt position so buckles are in the centre of the
seat. (Fig. 4.33)
Fig. 4.32
Adjust lap belt to suit the user's needs as follows:
To reduce the belt To increase the belt length
length
Feed free belt Feed free belt through slide adjusters
back through male and male buckle to provide more belt
buckle and slide length.
adjusters.
Ensure belt is not
looped at male
buckle.
When fastened check space between the lap belt and
user. When correctly adjusted it should not be possible to
insert more than the flat of the hand between the lap belt
and the user. (Fig. 4.34)
Fig. 4.33
Helium Rev.4.0