Basic Functions - Vitek VT-3465 Manual Instructions

mantle them, and do not subject them to high
temperature.
- replace the batteries in time.
Note:
When the unit is in the standby mode, it still
consumes power, to switch off the unit com-
pletely disconnect the power cord from the
socket.

BASIC FUNCTIONS

Adjusting volume
Use the VOLUME knob (1) to adjust the desired
volume level.
Increasing bass
Press the BASS (22) button to amplify low fre-
quency sound, the indicator (16) will light up.
Radio stations reception
1. Set the FUNCTION (4) switch to the RADIO
position.
2. Select the desired band: FM ST., FM or AM,
by setting the BAND (7) switch to the corre-
sponding position.
When tuning to the station, which transmits
stereo signal, the FM ST (15) indicator will
light up.
3. Rotate the TUNING (10) knob to select the
desired radio station.
4. After you stop listening to the radio, set the
FUNCTION (4) switch to the TAPE(OFF) po-
sition.
Antenna
For the best FM reception, completely extend
the FM ANTENNA and direct it at the desired
angle.
For the best AM reception try different variants
of the unit location.
Playback of CD discs
Loading – open the CD compartment lid. Insert
a CD disc and close the CD compartment lid.
Ejecting – after the playback stops open the CD
compartment lid and eject the disc. Put the disc
in the case for storage.
Always close the CD compartment lid in order
to prevent it from dust. Always eject a disc from
the CD compartment if it is not being played
back.
1. Plug the unit.
2. Select the CD playback mode. To do it, set
Downloaded From Disc-Player.com Vitek Manuals
3465IM.indd 5 3465IM.indd 5
the FUNCTION (4) switch to the MP3(AUX)
position.
3. If there is no disc in the disc slot or if the disc
is damaged, the "---"symbols will appear on
the LCD-display.
4. Open the disc slot. Insert a disc and close
the disc slot. Make sure that the disc is set
properly – with the label upwards.
5. Total number of tracks will appear on the
display.
Note: This unit can playback CD-R and CD-
RW discs
Playback
In the stop mode, press the PLAY/PAUSE but-
ton, the disc will start playing back and
the number of the track and "PLAY" will appear
on the display.
Pause
To pause the playback, press the PLAY/PAUSE
button in the playback mode, "Play" will start
flashing on the LCD-display.
To resume the playback, press the PLAY/
PAUSE button once again
Stop playback
To stop the playback, press the STOP
Total number of tracks will appear on the LCD-
display.
Moving to the beginning of the track, to the
previous and the next track
1. To move to the beginning of the played back
track press the button once in the play-
back mode.
2. To move to the next track, press the
ton once.
3. To move to the previous track, press the
button twice in the playback mode.
4. To move to the previous or to the next track,
if the playback is stopped, press the
buttons once.
Moving to a certain fragment of the disc
Press and hold the /
move to the certain fragment of the track in
the forward or backward direction (Sound will
not be played back until the
pressed). Press and hold the -10/FOL- or +10/
FOL+ button on the remote control to move to
the previous/next folder.
5
ENGLISH
button.
but-
/
buttons to quickly
/ buttons are
17.09.2010 10:46:23 17.09.2010 10:46:23