Installation And Configuration; Software Installation; Hardware Installation - National Instruments DAQ 6527 User Manual

Installation and Configuration

Software Installation

Note Install your software before you install your 6527 device.

Hardware Installation

Note Install your software before you install your 6527 device.
© National Instruments Corporation
This chapter describes how to install and configure your 6527 device.
Refer to the appropriate release notes indicated below for specific
instructions on the software installation sequence.
If you are using NI-DAQ, refer to your NI-DAQ release notes. Find
the installation section for your operating system and follow the
instructions given there.
If you are using LabVIEW, LabWindows/CVI, or other National
Instruments application software packages, refer to the appropriate release
notes. After you have installed your application software, refer to your
NI-DAQ release notes and follow the instructions given there for your
operating system and application software package.
The following are general installation instructions for each device. Consult
your computer or chassis user manual or technical reference manual for
specific instructions about installing new devices in your computer or
chassis.
PCI-6527
You can install a PCI-6527 in any available 5 V PCI expansion slot in your
computer:
1. Turn off and unplug your computer.
2. Remove the top cover or access port to the expansion slots.
2-1
2
6527 User Manual