Table of Contents
Advertisement
Control elements
7
Control panel
.04
The control panel is used to select seam programs, change parameter values, control the dif-
ferent operating modes, as well as for reading error signals and service settings.
The control panel consists of screen 1 with the appropriate displays and a row of function
keys.
7
Screen displays
.04.01
Depending on the operating mode, on the screen 1 information is shown about the machine
status, program selection, sequence program progress, input parameters, as well as error
signals.
7
Display symbols
.04.02
Program number
The current seam program number appears under this symbol.
Speed
The current speed appears under this symbol.
X
Size factor X (crosswise)
The size factor in X-direction in % appears under this symbol.
Y
Size factor Y (lengthwise to arm)
The size factor in Y-direction in % appears under this symbol.
Bobbin thread counter/piece counter
The current value for counting the piece or bobbin thread appears under this symbol.
Enter
If the key under this symbol is pressed, the input is concluded.
7 - 3
1
Activated functions are displayed with the triangular marking 2 beneath and next to the
respective function key.
Depending on the operating mode, relevant data is displayed in combination with the
appropriate symbol or text, and can be altered directly (e.g. speed 3 with the value 5).
When the parameters are entered, the number of the parameter selected is shown with
the corresponding parameter value, see Chapter 11.03 Parameter input.
After the input mode has been selected, the text 4 („TE") appears at the top edge of the
display, the input mode is activated, see Chapter 11 Input.
If faults occur in the sewing operation, a corresponding error signal appears in the display,
see Chapter 11.07 Error messages on the display.
3
4
P4
P5
P6
P7
P1
P2
P3
TE
X
Y
88
2700
100
100
5
2
P8
P
C1
C2
C3
TE
Advertisement
Table of Contents
