Related Manuals for ROBINHOOD RLES61SS/WH
Summary of Contents for ROBINHOOD RLES61SS/WH
- Page 1 Issue: 8 RLES,RI,RO Description: ROBINHOOD SLIDEOUTS Model RLES61SS/WH, RLES91SS/WH Numbers: RI61SS/WH RO91SS/WH RO61SS/WH/80 All dimensions in mm Model may vary slightly from images pictured...
-
Page 2: Safety Warnings
Safety Warnings All electrical work must be done by a registered electrician in accordance with local and national electrical codes as applicable. For your safety, this product must be earthed. If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. -
Page 3: Pre-Installation
Front Side Pre-installation Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control and every rangehood is tested and approved before it leaves the factory. Important: Please read the entire instructions before installing the rangehood. -
Page 4: Ducting Options
Please note that this chart is designed as a guide. Please consult Robinhood customer services if unsure. For NZ phone 0800 760 667 or www.robinhood.co.nz. For AUS phone 1800 648 556 or www.robinhood.com.au. -
Page 5: Changing The Handle
Pre-Installation - preparing the rangehood for installation Ducted rangehood If the rangehood is to be installed as a ducted hood, remove the appropriate duct knockout Changing the handle Using a Screwdriver, unscrew the 3 screw on the back of the Handle. Select the desired handle option from those available, and reattach the new handle using the same screws Recirculating Rangehood (for RO61SS/WH/80 only) If the Rangehood is to be installed as a recirculating hood, first ensure the overhead cabinets are built according... -
Page 6: Installation
Installation Minimum height from the hob surface to the underside face of the rangehood (wall or cabinet mounting) 600mm electric hob 650mm gas hob Note: If the instructions for the gas hob specify a greater distance, this has to be taken into account. Mounting to underside of cabinetry Fix the rangehood to a shelf mounted at the correct height in the wall unit, by drilling four holes (see diagram below) and fixing with the four screws supplied (found in the bag labelled “TOP FIXING”). - Page 7 Installation continued Mounting to the cabinetry sides When side mounting, the rangehood is fastened with countersunk screws and metal tubes through the plastic sides of the rangehood into the wooden sides of the cabinet above the cooking area. The screws clamp the metal tubes to the kitchen cabinetry and the rangehood effectively „floats‟...
-
Page 8: Cleaning And Maintenance
Operating instructions Light The light can be operated independently from the fan and is controlled in accordance with the graphics printed on the control panel. The fan can be run at different speeds depending on the cooking requirements and is controlled in accordance with the graphics printed on the control panel. - Page 9 The product was not used, cleaned or cared for in accordance with our instructions. The product was used outdoors. All Robinhood rangehoods are suitable for indoor use only, and not suitable over BBQs or charcoal cookers designed for outdoor use.
- Page 10 The product was used outdoors. 2. All Robinhood rangehoods are suitable for indoor use only and not suitable over BBQs or charcoal cookers designed for outdoor use. 3. In addition, this warranty does not extend to damage or defects which in our opinion, directly or indirectly arise from or are due to: exposing the product to acidic or corrosive materials or chemicals such as dyes, solvents, denture cleaner or acetone;...
Need help?
Do you have a question about the RLES61SS/WH and is the answer not in the manual?
Questions and answers