Installing Connector On Coax Cable; Ordering Repair Parts - Winegard Sensar HV Manual

Installing Connector on Coax Cable

Tools Needed: Strip outer cover back
12 mm from end of
Cable stripper
cable.
Compression tool
for compression
connectors
TIP
If installing in hot
weather, increase
Hex crimp tool for these dimensions 3 mm.
hex crimp connectors
Fray braid back as far Trim braid close to
as outer cover will outer cover, and
allow. remove 6 mm of
inner insulation, being
careful not to nick
the center conductor.
Make sure no foil
or braid can touch
center conductor.
Notes

ORDERING REPAIR PARTS

Slide connector tip
between braid and
Repair parts are available at many RV dealers and/or
inner insulation
service centers throughout the country. If you don't
(braid and foil, on foil
have a dealer/service center near you, call Winegard
Company at 1-800-288-8094. All major credit cards
shield cable). Push
accepted. Parts are available only in the packages
connector on cable
shown on the following pages. Order by the model
as far as it will go.
number of the package needed. Example: To order
Attach cable with
the elevating gear, order RP-3000. Tax, shipping and
proper crimping or handling additional.
compression tool. Do
not crush cable out-
of-round.
Parts
Mount
Worm Gear
Gear Housing
Nylon Bearing
Mounting Screw
Base Plate
Nylon Bearing
Nut
Directional Handle & Ceiling Plate
Ceiling Plate
Screw
Directional Handle
Decal
Nylon Bearing
Crank (white)
Plug
Q-Ring
(white)
(white)
Spring