Installing The Mounting Bracket - Winegard Sensar HV CC-10HV Installation & Operation Manual

5
Thread the 140 cm coax
between the boom and
the center of the bottom
element housing.
8 Connect the other end of the 140 cm coax to the 6.1 m coax using a barrel connector, and route the 6.1 m coax to
the location of the power supply.
If using a roof wedge or interior wedge, put in place before proceeding to install the base plate or interior hardware.
Center the elevating shaft in the 4.5 cm diameter hole. Check with your vehicle manufacturer
provided screws are suitable for your roof. Temporarily secure the base plate to the roof with two of the provided
screws. Check that the weather boot is in place over the boot collar.
Make sure the antenna is in the chosen location. The antenna
should be in the stowed/travel
should be routed through the ceiling and wall to the power
supply.
Apply a liberal amount of approved nonhardening
compound on the bottom of the base plate.
This will help to prevent leaks.
Do not get sealing compound
base plate and rotating gear housing.
Do not paint the top of the base plate or around the
rotating gear housing.
Using the provided screws, secure the base plate to
the roof. Run a solid bead of sealant over the mounting
screws. This will also help to prevent leaks.
Winegard Sensar HV Antenna
Assembling the Antenna, Cont.
6
Continue to thread the
coax in an S-curve
between the boom and
the bottom element
housing.

Installing the Mounting Bracket

position. The coax cable
sealing
on bearing surface between
7
Connect the coax to the
coax connection port,
and tighten until
fingertight. Then,
tighten ¼ turn more.
to determine if the
Travel Position
TIP
the mounting screws,
around the hole for cable
entry, and around the
bottom gear housing.
Run sealant around
the holes for
4