Special Key Sequences - Datalogic DL9600 Viper User Manual

4
Each section corresponds to a symbol that can be obtained using the corresponding
keyboard method according to the following scheme:
A) function of the numeric key when preceded by a SHIFT key press; if
pressing an alphabetic key after the SHIFT key, it switches between lower
and upper case characters;
B) function of the key when preceded by a FUNC key press;
C) function of the key when directly pressed.
4.4.3

Special Key Sequences

SCROLL
FUNC
E
INS
FUNC
CTRL
ALT
ALT
INS
CTRL
26
By pressing these keys and the terminal trigger
simultaneously, a system hardware reset is performed.
The behavior of the arrow keys may be overridden by the
FUNC - E sequence. This sequence toggles the arrow
keys between the standard and the "scroll control" modes.
When in standard mode, the arrow keys perform several
functions depending on the current application running.
When in "scroll control" mode, the arrows allow scrolling
the physical display on the virtual one (see par. 3.6.1).
You can enable the green LED on the bottom left position
of the screen to signal the keyboard state (see par. 3.6.1).
This sequence of keys performs a software system
DEL
reset and corresponds to the combination of CTRL,
ALT, DEL on the PC. Do not press these keys
BKSPC
simultaneously but always in the stated sequence.
The ALT key press preceding any keyboard key or
key sequence takes the same effect as on a
standard PC.
Ex.: ALT -FUNC - 8 corresponds to ALT - F8 on a
PC.
The CTRL key press preceding any keyboard key
or key sequence takes the same effect as on a
standard PC.
Ex: CTRL - J corresponds to CTRL - J on a PC.
DL9600 VIPER™