Table of Contents
Advertisement
3
3.7
EXIT MENU
ITEM
CMOS+EEPROM
Save & Exit
CMOS Save & Exit
Discard
Factory parameters
3.8
EXIT FROM THE SETUP PROCEDURE
To end the SETUP procedure, you will have to:
1-
Select the Exit menu by pressing [ESC]
2-
Select one of the items by pressing the correct key (an erroneous one re-enters
the setup procedure):
−
If you exit with saving, a message appears notifying that the program is
about to quit, and you can choose to reboot the DL9600 terminal to see the
effects of the new configuration. Remember that the DL9600 terminal
parameters are used by BIOS at boot-time.
−
If you exit with the "Discard" command, no change will affect CMOS and
EEPROM memories.
−
If you choose the "factory parameters", the application applies it and then re-
enters the setup procedure.
16
DESCRIPTION
Saves the new values in the
CMOS memory and
EEPROM memory and exits.
Saves the new values in the
CMOS memory and exits.
Discards the new values and
exits.
Load the default factory
values.
DL9600 VIPER™
NOTES
Press [S] to activate the
function.
Press [C] to activate the
function.
Press [Q] to activate the
function.
Press [D] to activate the
function.
Advertisement
Table of Contents
