Special Key Sequences - Datalogic DL9600 Viper User Manual

4
Each section corresponds to a symbol that can be obtained using the corresponding
keyboard method according to the following scheme:
A) function of the key when preceded by a SHIFT key press;
B) function of the key when preceded by a FUNC key press;
C) function of the key when in Alpha mode;
D) function of the key when preceded by a CTRL key press;
E) function of the key when directly pressed.
4.3.3

Special Key Sequences

SCRL SCRL E E E E
M M M M SCRL SCRL
◄
▲
FUNC
H H H H
ALT
O
CTRL
M M M M
N N N N
FUNC SHIFT
22
By pressing these keys and the terminal trigger
simultaneously, a system hardware reset is performed.
The behavior of the arrow keys may be overridden by the
FUNC - E sequence. This sequence toggles the arrow
keys between the standard and the "scroll control" modes.
When in standard mode, the arrow keys perform several
functions depending on the current application running.
When in "scroll control" mode, the arrows allow scrolling
the physical display on the virtual one (see par. 3.6.1).
You can enable the green LED on the bottom left position
of the screen to signal the keyboard state (see par. 3.6.1).
The ALT key press preceding any keyboard key or key
sequence takes the same effect as on a standard PC.
Ex.: ALT - F8 corresponds to ALT - F8 on a PC.
The CTRL key press preceding any keyboard key enables
the character positioned on the right upper part above the
key.
Ex: CTRL - 6 corresponds to the ˜ character.
The FUNC and SHIFT key press preceding any keyboard
key corresponds to the SHIFT + key press on the PC.
Ex.: FUNC - SHIFT - F5 corresponds to SHIFT - F5 on a
PC.
DL9600 VIPER™