Central Station Receiver 1 Account Number - NAPCO GEM-P1632 Installation Instructions Manual

07
BYPASS FIRE/TBL
INTERIOR
FIRE/TBL
INTERIOR BYPASS
(Direct Entry)
08
INTERIOR BYPASS FIRE/TBL
FIRE/TBL
INTERIOR BYPASS
(Direct Entry)
09
BYPASS FIRE/TBL
INTERIOR
INTERIOR BYPASS FIRE/TBL
(Direct Entry)
11
INTERIOR BYPASS FIRE/TBL
BYPASS FIRE/TBL
INTERIOR
(Direct Entry)
12
BYPASS FIRE/TBL
INTERIOR
FIRE/TBL
INTERIOR BYPASS
(Direct Entry)
For Central Station Telephone and Account Numbers: Use number buttons
G0
for a zero and
Dial-Tone Detection = "E". Pressing the
6
Programming the GEM-P816 & GEM-P1632
Entry/Exit Zones in Area 1
A
Press the
which are to be used as Entry/Exit zones. Valid entries are from 01 to 32. Di-
SYS TBL CHIME
rectly enter each zone number, including leading zeros.
Use number buttons
Press Jto save and then repeat for any additional zone(s). Press NEXT (E)
SYS TBL CHIME
button to proceed. NOTE: Chime will automatically be programmed for all E/E zones.
Interior Zones in Area 1
Press the
which are to be used as Interior Zones. Valid entries are from 01 to 32. Di-
SYS TBL CHIME
rectly enter each zone number, including leading zeros. Use number buttons
0
through
zone(s). Press NEXT (
SYS TBL CHIME
also be automatically programmed as "Exit/Entry Follower" zones.
Number of Keypads in Area 1
Press the
be installed in Area 1. Valid entries are from 01 to 07. Directly enter the
SYS TBL CHIME
number of keypads, including leading zeros. Use number buttons
9
through
NOTE: Area 2 keypads can only be assigned in Direct Address Programming.
SYS TBL CHIME
See Keypad Options.
Central Station Receiver 1 Telephone Number
Press the
number of up to 16 digits including prefix, if necessary, for receiver 1.
SYS TBL CHIME
SYS TBL CHIME
NOTE: Central Station Receiver 2 and 3 Telephone Numbers can be entered
in Direct Address Programming. See CS Reporting Options.
J
Press to save . Press NEXT (

Central Station Receiver 1 Account Number

Press the
four digits.
SYS TBL CHIME
SYS TBL CHIME
NOTE: Central Station Receiver 2 and 3 Account Numbers can be entered in
Direct Address Programming. See CS Reporting Options.
G 1 G 5
through
0
button will produce a blank space (•).
(Appears for New Panel Only)
button and then directly enter the zone number of any zones
0 9.
through
(Appears for New Panel Only)
A
button and then directly enter the zone number of any zones
J
9
. Press to save and then repeat for any additional
E
) button to proceed. NOTE: All Interior zones will
A
button and then directly enter the total number of Keypads to
J
. Press to save . Press NEXT (
A
button and using the number buttons, directly enter telephone
Central Station Receiver 1 Telephone Number
E
A
button and then directly enter an account number of up to
Central Station Account #
for letters B–F, respectively. NOTE: Pre-Dial Delay = "D";
E
) button to proceed.
) button to proceed.
1 9
through for digits 1–9; press
0