Cleaning & Maintenance - Bionaire BCH9300 Instruction Manual

the previous temperature setting. You will need
to reset the digital thermostat if the heater is
unplugged.
Oscillation
Press the Oscillation Button (
panel or remote control to activate or stop the
oscillation feature.
NOTE: Please do not manually turn the heater
on the base. It is designed to turn only by
motorized oscillation.
Timer
This heater is equipped with 8-Hour Auto Shut-
off Timer feature. This allows you to program
your heater to shut off automatically after
running a defined time interval (from 0 to 8
hours).
1. Press the Timer Button (
the control panel or remote control. The
"Hr" icon will begin to blink. The LCD
Display will show "0" and the "Hr" icon.
2. Each press of the button will adjust from 0 to
8 to select your desired time interval for the
heater to shut-off automatically. The selected
hour will appear on the LCD Display, and
then the "Hr" icon will stop blinking in to
indicate that the selected timer is activated.
The LCD Display will return to show the
preset temperature and mode setting.
3. To cancel the Timer feature, press and hold
the Timer Button (
Timer indicator light will go off.
NOTE: The timer does not work with the Frost
Guard Setting.
CLEANING/MAINTENANCE
Always unplug the heater before cleaning and
allow the heater to cool down.
1. Clean the unit with a soft cloth moistened
with a mild soap and water solution.
2. NEVER use abrasive or flammable solvents
to clean the unit.
3. After cleaning, be sure to completely dry the
unit with a cloth or towel.
4. Store heater in a cool, dry location.
5. It is recommended that you store the unit in
its original carton.
TIP: Over time, dust may accumulate on
the front grills. This can be removed by
wiping the unit with a damp cloth.
) on control
) once either on
) for 2 seconds, the
AUTO SAFETY SHUT-OFF
This heater is equipped with a technologically-
advanced safety system that requires the user to
reset the heater if there is a potential overheat
situation. When a potential overheat temperature
is reached, the system will automatically shut the
heater off. It can only resume operation when
the user resets the unit.
If the heater shuts down and the Power
Light is flashing:
1. Stand the heater upright.
2. Unplug the heater and allow 30 minutes for
the heater to cool down.
3. After 30 minutes plug the heater in and
operate normally.
4. If the heater does not work normally, repeat
steps 1, 2 and 3 again.
Tip Over Shut-Off:
When the unit is accidentally knocked over, it will
instantly shut off. The unit may also shut off if it
is moved or bumped. To reset, simply place the
heater in an upright position.
NOTE: Press Power Button (
heater will resume operation.
5
) once and