Advertisement
3. Connect the delta servos to Aileron-A and Elevator-A. The deltamixing
is done in the iGyro now. No mixing in the transmitter.
4. Connect the Vector Servos to Elevator-B and Rudder (a rudder control
with the iGyro is not provided in this setup, if needed, an addition
iGyro 1e
can be used)
5. Use an additional channel for the Gain. Set it to -100% to get all
surface working and check the gyro direction. Change it if necessary with
the button
6. The iGyro is now ready setup. You have two ranges:
- Range A: normal flying. Aileron and Elevator with Heading (if you don´t
want it, remove the checkbox), Vector gyro off (0%)
- Range B: 3D flying. Aileron, Elevator,Vector on, without heading
7. Fly and adjust Range A in flight with a gain slider. When you are done,
land and use the percentage value to put it on a switch, for example your
tested value is +48%. The switch also activates and deactivates the
vector control in the transmitter:
Switch Position 1: 0% - Gyro off, Vector control in the TX off
Switch Position 1: + 48% - Gyro on, normal flying, Vector control in the
TX off
Switch Position 1: - 100% - Gyro on, 3D Flying, Vector on, Vector control
in the TX on
For&more&details&for&your&Gyro&setup&you&can&contact&&
Ralph&Losemann:&rlosemann@aol.com&
Enrico&Thaeter:&enrico_thaeter@gmx.de&
The&designers&of&the&airplane&will&be&happy&to&assist!&
*I*Gyro*3e*sefng*
***
(Temporary)
Advertisement
