Control Panel Features - Westinghouse WHL1000 Owner's Manual

FEATURES

CONTROL PANEL FEATURES

1
1. Engine Control Switch (RUN/STOP for
Manual Start Units):
• RUN - In the RUN position, the switch
allows the generator to be started (for
manual start models).
• STOP - In the STOP position, the switch
stops the engine.
2. Hour Meter: Displays how many hours the
generator has been run when under load.
3. Main Circuit Breaker: The main circuit
breaker controls total output of all outlets to
protect the generator.
4. 120/240-Volt, 30-Amp Twist Lock Outlet
(NEMA L14-30R): Outlet can supply either
120V or 240V output.
5. 120-Volt, 20-Amp Duplex GFCI Outlets
(NEMA 5-20R): Each outlet is capable
of carrying a maximum of 20 amps on a
single receptacle or a combination of both
receptacles.
18
8
3
2
Figure 11 – Control Panel Features
4 5
6
6. 20-Amp Circuit Breakers: Each circuit
breaker limits the current that can be
delivered through the 120-volt duplex outlets
to 20 amps.
7. Ground Terminal: The ground terminal is
used to ground the generator.
8. Engine Control Switch (START/RUN/STOP
for Electric Start Units):
• START - When the switch is momentarily
depressed and held in the START position,
the electric start motor engages and starts
the engine. Once the engine starts, release
the switch. (The switch will automatically go
to the RUN position.)
• RUN - Once started, the switch will remain
in the RUN position.
• STOP - To stop the engine, move the switch
to the STOP position.
7