Channel Control Punch Through - Universal Remote Control WR7 Owner's Manual

Channel Control Punch Through

This punch through lets you set up the WR7
remote so that either the Cable or TV Channel
Controls (CHANNEL UP , DOWN, LAST,
CHANNEL NUMBERS 0-9, +10 and ENTER)
will also operate in other component modes on
the remote control.
STEP 1: Press and hold the component
button you want to add channel control to, such
as [DVD] or [VCR], and the SELECT [SEL] button
at the same time for two seconds until the
Component light turns on. Release the buttons.
COMPONENT
BUTTONS
SELECT
BUTTONS
STEP 2: Press the CHANNEL UP [CH
button. The component LED light will blink once.
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set up mode, and you
will have to start over with step one.
STEP 3: Press either the [TV] or [CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink three times to confirm it is saved.
5
]
Page | 26