Erasing All Learned Commands From One Component - Universal Remote Control WR7 Owner's Manual

Erasing All Learned Commands from
One Component
This function allows you to erase all the
learned commands from one component.
For example, if you want to erase all
learned commands on the TV component
button because you bought a new TV, the
process is very simple.
STEP 1: Press the component button where
all the learned commands are stored and
the [ENTER] button at the same time for two
seconds, until the component LED turns on.
STEP 2: Press and hold both the component
button you want to erase and the [PAUSE]
button at the same time for two seconds, until
the component LED light blinks twice to confirm
the erasure.
COMPONENT
BUTTONS
PAUSE
ENTER
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step one.
STEP 3: To exit Erase mode, press and hold
both the component button and the [ENTER]
button at the same time until the component
LED light blinks three times.
Page | 31