Universal Remote Control WR7 Owner's Manual page 20

What to know before you start:
• You can program up to 20 sequential
commands on a Macro button.
• You can program delays in between
commands by pressing the [PAUSE]
button on the transport control.
– Each press adds a one-half second delay.
– If you add the delay time as the first step
of Macro commands, the remote will not
send the Macro unless the button is held
for two seconds.
• You can set up macro commands in layers
by pressing the [STOP] button in between
commands. This will allow you to rotate
commands, and is typically used to program
channel lists. For example, when working the
"My Favorites" button, if you press [009],
[STOP], [035], [STOP], [365], [STOP] the
remote will send out 009 at the first press of
the selected [My Favorites] button, and then
send out 035 at the second press, etc.
• You cannot set-up the [CH
[PAUSE
• You also can set up the "FAV" button above
the channel control as a favorite macro (like
watch a movie), or you can save it to learn
your favorite channel list from your cable/SAT
remote control.
Page | 19
;
] buttons with macros.
56
] or