Location Of Dimm Sockets - Intel DK440LX Product Manual

Figure 11 shows the location of the DIMM sockets.
NOTE
There may be mechanical interference with the DIMM 0 socket and the DIMM 1 socket (see
Figure 11) in some combinations of ATX chassis and peripherals (such as CD-ROM drives).
To install DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" (see page 17).
2. Turn off the computer, disconnect the computer's power cord, and disconnect all external
peripherals.
3. Remove the computer cover and locate the DIMM sockets (see Figure 11).
4. Hold the DIMM by the edges; remove it from its antistatic package.
5. Make sure the clips at either end of the socket are pushed away from the socket.
6. Position the DIMM above the socket. Align the two small notches in the bottom edge of the
DIMM with the keys in the socket (see Figure 12).
7. Insert the bottom edge of the DIMM into the socket.
8. When the DIMM is seated, press down on the top edge of the DIMM until the retaining clips at
the ends of the socket snap into place. Make sure the clips are firmly in place.
9. Replace the computer cover.
Figure 11. Location of DIMM Sockets
DK440LX Motherboard Product Guide
3
2
1
0
OM06326
29