Table of Contents
Advertisement
Determining the Mounting Position
of the Post Bracket Assembly and the Gate Bracket
Step 1
3
1
Insert the
/
" x 1
/
"
8
2
bolt through the center
hole of the post brackets
and post pivot bracket
as shown. Fasten a
3
washer and
/
" lock nut
8
on the end of the bolt.
DO NOT overtighten the
lock nut because the
post pivot bracket will
have to be adjusted later.
Step 2
Attach post bracket assembly to the rear mount of the opener with a clevis pin and a 3/8" washer. Secure
the clevis pin with a hairpin clip. Attach gate bracket to the front mount of the opener with a clevis pin and a
3/8" bushing. Secure the clevis pin with a hairpin clip
Clevis Pin
Rear Mount
3/8" Washer
Hairpin Clip
Post Bracket Assembly
Step 3
With the gate in the open position (up to 110º from its closed position), and the opener fully retracted,
adjust the post bracket assembly and gate bracket until the opener is level. While holding the opener level,
use C-clamps to temporarily keep the post bracket assembly and gate bracket in their respective positions
on the fence post and gate.
14
3
/
"
8
Opener
Post Bracket Assembly
Level Opener
Gate In Open Position
Fence Post
3/8" x 1-1/2" Bolt
Post Pivot Bracket
Post Bracket
3/8" Washer
3/8" Lock Nut
M i g h t y M u l e 2 0 0
REMINDER:
The following steps are
intended for pull-to-open
gate installations only.
Front Mount
Bushing
Gate Bracket
Hairpin Clip
Gate Bracket
Clevis
Pin
Hide quick links:
Advertisement
Table of Contents
