Installing The Closed Position Stop Plate / Pull-To-Open - Mighty Mule TS571W Installation Manual

PULL-TO-OPEN OPERATOR MOUNTING
Your Property
Step 10
● Secure the gate bracket with the
supplied hardware as shown.
P
Step 11
● Once the gate post and gate
brackets are installed, reattached
the operator arm.
● Ensure the operator arm is level,
V
adjusting the post bracket location
T
if necessary.
L
● Once level, ensure all hardware is
tight.
● Remove excess bolt length with a
hacksaw.
6
TS571W Installation Instructions
V
T
L
L
N

INSTALLING THE CLOSED POSITION STOP PLATE / PULL-TO-OPEN

Your Property
Step 1
N
● Remove the operator from the
gate post and gate brackets.
● With the gate fully open, install
the closed position stop plate
(hardware not included).
● Do not fully tighten hardware
until after the next step.
Step 2
● Swing the gate to the closed
position, and adjust the closed
position stop plate against the
fence post.
H ● Tighten the mounting hardware.
● Return the gate to the open
position and reinstall the operator
arm.
● To complete the pull-to-open
installation, proceed to page 14.
H
1
Fence Post
1
TS571W Installation Instructions
7