Clock Adjustment; Range To Empty - Triumph Rocket III Handbook

Clock Adjustment

Warning
Do not attempt to adjust the clock with the
motorcycle in motion as this may lead to
loss of motorcycle control and an accident.
To set the clock, turn the ignition to the ON
position. Press and release the reset button
until the clock is visible in the display screen.
Press and hold the reset button for
4 seconds. After 4 seconds either 24 Hr or
12 Hr will be shown flashing. Press and
release the reset button to select the desired
clock display. When the correct display is
shown, do not touch the reset button until
the clock is shown with the hour display
flashing.
To reset the hour display, ensure that the
hour display is still flashing. Press the reset
button to change the setting. Each individual
button press will change the setting by one
digit. If the button is held, the display will
continuously scroll through in single digit
increments.
When the correct hour display is shown, do
not touch the reset button for 6 seconds. The
minutes display will begin
automatically. The minutes display is adjusted
in the same way as for the hours.
Once both hours and minutes are correctly
set, do not touch the reset button for
General Information
6 seconds and the display will cease to flash
automatically.
2
cfzs_2
1. Clock display
2. Hours read-out
3. Minutes read-out

Range to Empty

This is an indication of the predicted distance
that can be travelled on the remaining fuel in
the tank. It is displayed when the ignition
switch is turned to the ON position.
to flash
cfzs 6
1. Range to empty
1
.
.
3
1
.
21